...

• Point(s)
  • A point is a grouping of sensors in one area of the building. If a point has a fault, something is tripping a sensor in that area.
• All On
  • This refers to the armed points. All on means every point is enabled.
• Part on
  • This refers to the armed points. This enables most points but some special designated points are still disarmed.

Arming the System

To arm the system please do the following:

1. Verify the lock logo is green. This indicates the system is ready to be armed.
   1. 
2. Press the ★ icon
   1. Image Modified
3. Select "Arm with delay"
4. When the timer starts, exit the building.
   1. 

Disarming the Alarm

Alarm will disarm automatically when an exterior door is opened using the card system. 

Alarm Not Ready to Arm

If the alarm will not enter a ready state, follow the steps below:

1. To view the issue, select "View Pts". This stands for view points.
   1. 
2. You should now see a list of faulted points. Scroll through them with the left and right arrows.
   1. 
3. Go to the area in the building with the issue and resolve the fault. Once cleared the screen should look like this:
   1. 
4. You may now arm the alarm.

Resetting Alarm After Fault

If the alarm goes off, follow this procedure: 

1. Silence the alarm. Touch the red alarm icon.
   1. Image Modified
2. Fix the problem in the building (Close open door, papers waving in front of motion sensor, ect)
   1. Image Modified
3. Once the system is disarmed, view the events with the icon in the upper left hand corner.
   1. Image Modified
4. Once cleared the system should return to:
   1. Image Modified